G&G PCC45

This G&G PCC45 AEG airsoft replica has a highly compact design which can be made even more compact thanks to the foldable stock. Folding it will allow you to easily transport and store the replica and you can even use it while folded during CQB, in which manoeuvrability is an important factor. Even with the stock extended, the replica has a length of only 740 mm, so it can still be used perfectly fine to quickly round corners. There’s a Weaver/Picatinny scope rail on top of the upper receiver that extends along the handguard and it comes supplied with foldable front- and rear sights. Those front and rear sights can be used to aim accurately, but they can also be taken off completely if you’d rather use something like a red dot.

There are multiple M-LOK slots on both sides of the handguard, which can be used to mount various accessories to further customise the G&G PCC45 to your preferences. Pulling the lever on the bottom of the handguard will allow you to slide the handguard off of the replica to get to the battery compartment.

The fire selector can be used to switch between semi-automatic and fully automatic firing modes. Pulling the trigger for ten seconds will allow you to replace the fully automatic firing mode with a 3 BB burst mode. The fire selector can be operated from both the left side and the right side of the housing and the same goes for the magazine pin, the charging handle and the bolt catch. Pulling the charging handle back will open the ejector’s dust cover, so you can get to the adjustable hop-up. The ejector is kept open by the functional bolt catch.

This G&G PCC45 airsoft replica comes supplied with a magazine with a capacity of 110 BBs. The magazine is see-through and it’s filled with mock rounds, granting even more realism to the already realistic design.